SS Cut Milspec Trigger Shoe
Milspec AR-15 trigger shoe, with super safety cut. The geometry work is already done, so you skip the send-in wait and you never put a file to your own trigger…
Milspec AR-15 trigger shoe, with super safety cut. The geometry work is already done, so you skip the send-in wait and you never put a file to your own trigger.
What the cut does
The relief on the shoe tail is what lets a Super Safety or a MARC reset the trigger for you. Get that geometry wrong and you get a sluggish reset, a bind, or a part that will not run at all.
We cut these on the bench that builds the MARC, on the same fixtures and to the same inspection we hold our own parts to.
What ships
The cut trigger shoe, with all pins and springs included. Nothing to source separately before you build.
If you would rather have your existing trigger group cut, send it to us through the Trigger Cutting Service instead and we will cut, deburr and function test it.
Your build still has to match
A cut shoe is one piece of a working active reset setup. You also need an M16-cut bolt carrier, a low-shelf lower, and buffer weight matched to your gas system. The MARC installation guide carries the tuning tables.
The cut removes material and it is permanent.
This part is for lawful semi-automatic use and produces one discharge per trigger pull. You are responsible for the state and local regulations where you live.
Not sure this is the right part for your build? Email admin@copperheadsafety.com before you order.
